It was fun poling holes in the recent story about a tiny hole poked in the International Space Station which an astronaut held his finger over until Russian cosmonauts patched it with a modern version of chewing gum and duct tape. Funny stuff … until it was revealed that the hole was not the result of a micrometeorite impact but an accidental drill hole made by a Soyuz contractor who himself had patched it up so the capsule could pass inspection.
by Paul Seaburn (Mysterious Universe)
September 16, 2018
Unfortunately, that wasn’t the end of it. Further inspections by the crew have found evidence of more mysterious drill dents and unexplained scratches … this time on the outside. Don’t shout “Aliens!” … yet.
“Traces of drilling have been found not only inside the spacecraft’s living compartment, but also on the screen of the anti-meteorite shield that covers the spacecraft from the outside and is installed 15 millimeters away from the pressure hull.”
That chilling revelation was given to the TASS news agency by “a rocket and space industry source.” Prior to plugging the two-millimeter hole discovered after pressure began to drop in the ISS on August 30th, cosmonauts conducted an extensive examination of the area surround it both inside and out. Photo and video images taken of the outer hull using an endoscope (that cheer you just heard was from gastroenterologists) showed more evidence of non-reported-or-repaired drilling.
“During the analysis of those images, traces of drilling were found on the anti-meteorite shield … the top of the drill came through the pressure hull and hit the non-gastight outer shell.”
With that discovery, the finger-pointing began. The non-gastight anti-meteorite outer shell is the last piece installed before the spacecraft is taken to the final assembly workshop…
Read More at MYSTERIOUS UNIVERSE
